GREAT PLANES BLT, Инструкция по эксплуатации

Страница: 16 / 24

❏
1. Before starting the radio installation, put the motor
battery on your charger. Then, when the battery is required
for the radio installation, it will be charged.
❏
2. Clean the bottom of the rudder and elevator servos
with rubbing alcohol. Apply a piece of double-sided tape
(not included) to the bottom of each servo.
❏
3. Remove the backing from the double-sided tape and
insert the servos into the holes in the side of the wing pylon
so that the double-sided tape is attached to the inside of the
wing pylon.
❏
4. Plug the two servos and the electronic speed control
into the micro receiver following the receiver manufacturer's
instructions. Place the electronic speed control and receiver
inside the wing pylon.
❏
5. Cut a small hole in the front of the wing pylon and route
the receiver antenna and plugs for the motor and motor battery
out through the front. You can glue a couple of small pieces of
the white tube to the bottom of the fuselage and route the
receiver antenna through the tubes towards the tail.
Follow these assembly instructions for the Great Planes ElectriFly ™
T-280GD ESC motor system and gear drive (GPMG0430).
❏
1. Use denatured alcohol or other solvent to clean the
motor shaft. Roughen the shaft with 320-grit sandpaper so
glue will adhere.
❏
2. Apply a small drop of medium CA to the hole in the
pinion gear, then press the gear onto the motor shaft using
the base of a large screwdriver or something similar. While
doing this, do not rest the base of the motor on your
workbench, but support the motor shaft with a piece of
hardwood. This way, the pressure applied to the gear will
not displace the armature in the motor.
❏
3. Press the motor by hand as far as it will go into the
gear drive unit. If it is a loose fit, secure the motor to the
gearbox with a small drop of CA.
ASSEMBLE THE GEAR DRIVE
Mount the Servos
RADIO INSTALLATION
16