29
❏
3. Position the hatch on the fuselage.
❏
4. Test fit the windscreen on the hatch. Trim as necessary.
❏
5. Mark the outline of the windscreen.
❏
6. Use a T-pin to poke holes along the inside of the outline.
❏
7. Wipe off the marks. Remove the hatch from the fuselage
and glue the windscreen to the hatch with Canopy Glue.
Apply the Decals
1. The decals are die-cut from the factory.
2. Be certain the model is clean and free from oily fi ngerprints
and dust. Prepare a dishpan or small bucket with a mixture
of liquid dish soap and warm water—about 1/2 teaspoon
of soap per gallon of water. Submerse one of the decals in
the solution and peel off the paper backing.
NOTE:
Even
though the decals have a “sticky-back” and are not the
water transfer type, submersing them in soap & water allows
accurate positioning and reduces air bubbles underneath.
3. Position decal on the model where desired. Holding the
decal down, use a paper towel to wipe most of the water away.
4. Use a piece of soft balsa or something similar to squeegee
remaining water from under the decal. Apply the rest of the
decals the same way.
Please use the box top as a guide for the decal placement.
