20
❏
11. Center the rudder and servo arm. Attach a 4-40 solder
clevis to the rudder servo horn. Mark, cut and solder the
clevis on the rudder pushrod following the same procedure
used for the aileron pushrods.
❏
12. Reinstall the rudder pushrod.
❏
13. Install the elevator pushrods following the same
procedure used for the rudder.
Nose Gear Steering
(for optional nose gear)
❏
1. Trim and glue the outer pushrod tube.
❏
2. Install the screw-lock pushrod connector on the rudder
servo arm.
❏
3. Cut the 2-56 x 24" (61mm) pushrod.
❏
4. Put a Z-bend in one end of the steering pushrod.
