30
GET THE MODEL READY TO FLY
Check the Control Directions
❏
1. Switch on the transmitter and receiver.
❏
2. Center the control surfaces.
❏
3. We plugged the Y-harnesses into the receiver for the
aileron and flaps or the 300 mm hub into the S.Bus port.
These were then taped to the center former.
FULL
THROTTLE
RUDDER
MOVES
RIGHT
ELEVATOR
MOVES DOWN
RIGHT AILERON
MOVES UP
LEFT AILERON
MOVES DOWN
4-CHANNEL RADIO SET UP
(STANDARD MODE 2)
❏
4. Make certain that the control surfaces and the carburetor
respond in the correct direction as shown in the diagram.
If any of the controls respond in the wrong direction, use
the servo reversing in the transmitter to reverse the servos
connected to those controls. Be certain the control surfaces
have remained centered. Adjust if necessary.
Set the Control Throws
❏
1. Hold a ruler against the widest part of the control surface
and measure the high rate throw fi rst.
