GREAT PLAINS Super Kybolt, Руководство пользователя

Страница: 57 / 72

D 2 Tack glue the die-cut 3/32" balsa rear belly
former (SKY642) in place against former F3 and
the wing TE Sand it until it matches the contour of
the fuse bottom.
D 7 Remove the wing, and enlarge the holes in
the fuselage wing bolt blocks only to 19/64"
(5/16" will work) Flatten out or cut off the teeth"
on the two 1/4 blind nuts, and insert them into the
bolt blocks They should be inserted from the top
of the block and glued in place with thick CA or
epoxy Be careful not to get glue on the threads
D 8 Enlarge the front wing bolt hole in the wing
bottom sheeting to 1/2" diameter so the head of
the bolt will fit through Test fit the wing in place
with the two 1/4-20 nylon bolts (NYLON13)
NOTE You may cut approximately 3/4" off of each
bolt to make them easier to install.
D 3 Carefully remove the belly formers, and draw
an arc 3/32" inside the curved edge of both
formers Cut and sand the former down to the new
arc This will allow for the 3/32 belly sheeting to be
installed flush with the fuse bottom
D 4 Glue the front belly former to the wing LE
approximately 1/32" behind F2 Do not glue the
belly formers or the wing to the fuselage!
FINAL ASSEMBLY
BUILD THE BOTTOM WING
FAIRING
D 1 Final sand the bottom nose of the fuselage to
obtain the smooth shape shown on the fuselage
cross sectional views Install the wing on the fuse,
and tack glue the die-cut 3/32 balsa front belly
former (SKY6W42) in place against former F2 and
the wing LE Sand it until it matches the contour of
the nose bottom
D 5 Glue the rear belly former to the wing TE
approximately 1/32" in front of F3 Do not glue
the belly formers or the wing to the fuselage!
- 5 7 -