GREAT PLAINS Super Kybolt, Руководство пользователя

Страница: 30 / 72

ribs (SKY6W11) Carefully glue one B5B rib to each
B5A rib using thick CA Use the glue sparingly to
avoid getting glue in the l-strut cut-outs
"flashing" off the edges Be careful to cut at the
angle shown so you don't change the width of the
leading edges during this step
D D 9 Carefully glue a B5B in place on the other
side of each B5A Again be careful with the CA to
avoid getting it in the l-strut cut-outs
D D 10 Glue a B5 assembly in place on the spar
with the cut-outs (slots) on top
D D 11 Glue the top spar in place (with the
doubler down) Make sure it is fully seated in the
notches so it does not protrude above the top
surface of the ribs Remember, the spar doubler
stops just before the first B4 rib
D D 12 The shaped balsa Leading Edges
(SKY6W15) are connected by a thin strip of balsa.
Cut the two LE'S apart and carefully trim the
D D 13 Line up the 3/8 wide notch in the LE with
the B5 rib assembly and test fit the leading edge in
place Center (vertically) the LE on each rib and
glue it with CA.
NOTE: In the following steps you'll find
it necessary to remove some of the pins
holding the wing down to your building
board. As you do, take other steps as
necessary to continue holding the wing
down, such as by applying weight to the
top of the wing, or by relocating the
pins.
D D 14 Glue the pre-cut 1/16" balsa vertical grain
shear webs (SKY6W27) to the rear edge of the
spars in the first 7 rib bays (from B3 to B5) Also
glue shear webs onto the front edge of the spars
in the first 4 rib bays NOTE: You may wish to trial
fit and trim each web before gluing it in The webs
must be securely glued to the spars
D D 15 Trim off the root end of the spars and TE
slightly longer than their correct length (approx 1/64"
longer) Later, when the two wing halves are joined
together, they will be sanded to the correct length.
-30