GREAT PLAINS Super Kybolt, Руководство пользователя

Страница: 53 / 72

ONE AILERON SERVO
D 21 Glue the outer TE in place approximately
1/16" away from the aileron Look down the trailing
edge of all three pieces to make sure they are all
aligned with each other.
D 1 Cut a notch in each grooved balsa bottom
wing center TE (SKY6W40) The notch should be
3/4" from one end, and only needs to be in the top
side of the groove Make a right and a left piece as
shown in the photo.
D 22 Cut and sand the tip of the wing to match
the outline on the plans Sand the entire wing tip
smooth.
D 23 Remove the aileron, and bevel the front
edge to a "V" shape as shown in the cross section
view on the plans
D 2 Roughen the short end of the aileron torque
rods with 100-grit sandpaper, and file the same
end to a wedge shape as shown in the sketch
above Also roughen the outer surface of the
plastic bearing tubes.
D 3 Trial fit the torque rods into the center TE
pieces, and hold or tape them against the wing TE.
Mark on the wing TE where to cut notches to allow
the torque rods to rotate forward The threaded
portion of the torque rods should be on the top
surface of the wing! Sand the two TE pieces so
they will join properly at the center of the wing
D 24 Place the aileron over the aileron drawing
on the bottom wing plan, and mark where the
hinges should go Hold the aileron in place on the
wing, and transfer the marks over to the wing Cut
the hinge slots following the hinge slotting
guidelines on page 10 Skip the next section
(One Aileron Servo) if you are installing two
aileron servos.
D 4 Clean the torque rods and bearing tubes with
alcohol Slide the plastic bearing tubes toward the
threaded end of the torque rods Then use a
toothpick to apply Vaseline to both ends of the
bearing to keep glue from getting inside the bearing.
- 5 3 -