GREAT PLAINS Super Kybolt, Руководство пользователя

Страница: 42 / 72

FINISH THE TOP WING
edge and mark where to cut it to fit next to the
center trailing edge. NOTE: We are referring to this
piece as an aileron even though it won't actually be
an aileron.
D 2. Cut the aileron off at this mark and test fit it in
place. Sand the root end if necessary to achieve a
good fit and glue it to the TE and the center TE.
Make sure it is lined up perfectly with the chord line
of the airfoil as you did earlier for the center TE.
D 32. Sand the entire trailing edge of the wing to
remove any overlapping sheeting. Measure and
mark the center of the front edge of the 6-1/4" long
balsa center trailing edge (SKY6W19) and make
a mark there. Center this part on the ply trailing
edge brace and glue it in place with thick CA.
Make sure it is straight and perfectly aligned with
the chord line of the airfoil (see sketch below).
D 3. Cut the tip end of the aileron off following
the contour of the wing tip, and sand the entire
wing tip smooth. Skip ahead to "Build the
Interplane Struts."
IF YOU ARE INSTALLING
AILERONS ON THE TOP WING
SKIP TO STEP 4
D 1. Hold a 17/32" x 2" x 28" tapered balsa
aileron (SKY6W18) in place against the trailing
D 4. Position a 17/32" x 2" x 28" tapered balsa
aileron (SKY6W18) on the top wing plan and line it
up with the trailing edge on the left wing panel. Use
the cutting marks drawn on the plans to make the
three required cuts. You will now have an inner
TE, an aileron and an outer TE.
D 5. Draw a centerline along the aft edge of both
trailing edges and the leading edges of both
ailerons. This will help keep the hinges centered later.
42