M10 JEWEL Machine - Electronic Engraving Machine
. 38
First Contact
1. Place the 3 ring/bracelet jaws (D3) in position (the white arrows (F2) must
be apart from the zone of tightening) onto the chuck, (1) and (2), and then
position the green marks to the outside of the chuck (3).
2. Mark the middle of the text length to be engraved on the Outside of the bracelet
3. Place the bracelet so that the mark is at the bottom and is aligned with the directional arrow
(J3).
4. Using the tightening ring (K) of the chuck, fasten the bracelet firmly in place so it will remain
immobile during engraving.
Proper fastening contributes towards reducing machine noise and vibrations during engraving.
Check that the object is properly fastened so it does not pop out during engraving and
that no object poses an obstacle to the movable parts’ movements.
Positioning a wide bracelet onto the jaws and Outside Engraving
1/3
Outside diameter
Middle of the text
length
Outside Engraving
5. Touch (START) on the control panel of the machine and follow the instructions indicated on
the screen of the computer:
