M10 JEWEL Machine - Electronic Engraving Machine
. 24
First Contact
5. Loosen the 2 screws (V1) (in the center of the chuck) slightly
2/2
6. Turn the diamond tip (D1) (for rings) at 90° (the tip on the left) (1). Insert it (2) and turn it at
90° (3) in the anti-clockwise direction (the tip is directed downwards) . Tighten the 2 screws
(V1) to immobilize it.
7. Touch (START) on the control panel of the machine, to start the engraving.
For your own personal safety and to avoid any risks of being crushed by the machine
during engraving, do not stand near the tools.
In the event of a problem, touch
(PAUSE) to stop the engraving process
The machine will momentarily pause.
To continue with the rest of the engraving, touch
(START)
To stop engraving completely, touch one of the arrows of the joystick.
Engraving is finished, when the machine is ready to receive
a new file:
You can remove the ring, or launch again the engraving process for a better
result.
