First Contact
M10 JEWEL Machine - Electronic Engraving Machine
. 21
Positioning a thin ring onto the jaws and Inside Engraving
1/2
3. Place the ring so that the mark is at the bottom and is aligned with the directional arrow (J3)
4. Using the tightening ring (K) of the chuck, fasten the ring firmly in place so it will remain
immobile during engraving
Proper fastening contributes towards reducing machine noise and vibrations during engraving.
Check that the object is properly fastened so it does not pop out during engraving and
that no object poses an obstacle to the movable parts’ movements.
1. Place the 3 ring/bracelet jaws (D3) in position (the white arrows (F2) must be apart from the
zone of tightening) onto the chuck, (1) and (2), and then position the red marks to the chuck
center (3).
Inside diameter
Middle of the text
length
Inside engraving
2. Mark the middle of the text length to be engraved on the Inside of the ring :
