Gravograph Machines - Soft setup
Setting softlink between PC and engraving machine
USB connection
1. Plug a single machine onto an USB port of your PC. Power up it.
> Plug machine onto port, power up it
2. The setup wizard checks the compatibility between L-Solution 5.xx-3
and machine firmware (embedded program that carries out engraving
instructions).
• When compatibility is ok, the wizard jumps to step 4.
• Otherwise the last firmware version will be set up. Machine beeps when
operation is over.
> Updating firmware
3. Power off your engraving machine, then power up again.
> Power off machine
> Power up machine
4. The machine is automatically detected as new device on an USB
port of your PC.
Click "Software correctly installed" in Software
compatibility wizard of Windows Vista.
In Windows XP Add new detected device wizard asks if
devices plugged onto your PC should be checked.
a.
Click "Not this time."
Next>
Click.
b. The wizard asks if you expect Windows to set up machine
driver.
Click "Install software automatically
(recommended)".
Next>
Click.
c.
A message notifies that driver is not Windows certified.
Continue
Click.
d.
Finish
Click when setup is over.
5. In Start menu or in Control panel double-click Printers: check that
your machine is displayed as new L-Solution printer
6. Give this printer the name of your engraving machine.
6
