L-SOLUTION 100 Ex Fibre machine
. 70
First contact
Positioning the plate
The next step consists of loading and positioning the keychain on top of the engraving table inside the LASER system. Open
the front door and position the keychain into the upper left hand corner of the table against the rulers as indicated below :
Running the machine
Focusing the LASER beam
Before attempting to adjust the focal height, visually check to make sure that the table is down low enough to prevent
the focus carriage from hitting into the keychain.
Using the Autofocus method, the proper focal height is automatically adjusted (Zref. auto).
Autofocus method :
Press
key. Autofocus starts automatically.
You can activate the Autofocus function in the printer driver of your LASER engraving machine. In that case Autofocus
starts automatically before each engraving start (next paragraph).
Do not activate this Autofocus function when you want to engrave a series of plates
with the same thickness. In that case you carry out an Autofocus only for the first plate.
Therefore you gain time.
