GRAUPNER/SJ GmbH 73230 KIRCHHEIM/TECK GERMANY
Subject to modification! No liability for printing errors!
03/2018
-
10
-
Fasten the parts (22) and (23) to the fuselage and glue them together. Glue the pin
(6a) into the rib (6). Glue the upper part of the magnetic lock (25) into the part (22),
press the metal tabs flat. Remove the cab frame from the fuselage and sand it. Glue
the cab cover (24) with UHU Kraftkleber superstrong and cut off the protruding
edges. Press the cab hood with the lower part of (25) on the fuselage. If everything
fits together, glue the lower part of (25) (together with the cabin cover). Apply
adhesive tape between the two parts (25) so that they do not stick together. Form the
fuselage using a balsa plane and a sanding block according to sections A-A, B-B and
C-C. After covering the model, glue the dowels (96) in place with a cyano adhesive.
Elevator
Lay the building plan 1 on the building surface and cover the area of the tail plane
with a clear plastic film so that the components do not stick to the plan.
