GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved. No liability for printing errors
12/2010
0062196
9
The servos are centred by switching on the RC system and setting the trims to
neutral.
The next step is to glue the servos to the servo well covers, but first you will need to
solder the servo leads to the extension leads (already present in the wings), and
remove the servo mounting lugs. Solder the joints carefully, ensuring that you main-
tain correct polarity, i.e. connect like colours of wire together. Insulate each soldered
joint with a separate heat-shrink sleeve, which must be fitted onto the wire before the
joint is soldered.
The servos can now be glued to the covers as shown in the photo: the output arm
must be positioned in the centre of the pushrod fairing, and there should be an 8 mm
gap between the servo and the edge of the moulding, as shown below.
Thoroughly sand the servo well cover and the servo case before gluing them
together.
It is possible to use cyano, Order No. 5821, for these joints, but in this case you must
ensure that the servo is positioned correctly “first time”, i.e. you will have no oppor-
tunity to adjust the servo position if you use cyano.
