Zodiak Installation and Service Manual
267
DPM CPL Interface
Figure 178. Ports & Devices – Device Details – GVeous
Configure and Assign Aux Buses
In the Device Details pane for a DPM device, Zodiak Aux buses can be
assigned to provide the inputs to available DPM channels. Up to five DPM
channels can be fed by Zodiak Aux buses. The assignments in this menu
provide information to establish a communication link between the Zodiak
and the DPM for controlling Front/Back switching logic on the Aux buses.
If Aux buses have not yet been configured, you will need to configure the
Aux buses, then assign them to DPM channels with the steps below. If Aux
buses are already configured, proceed to
of this procedure.
1.
In the Ports & Devices, Device Details menu (
),
touch the
Config
Outputs
button below the Aux Buses data pad (or touch
the
Outputs
button at the bottom of the screen) to access the Outputs
This menu is used to name, pair, and assign physical Aux bus outputs
to the logical Aux buses in the switcher.
2.
Touch an Aux bus number in the Physical Outputs pane on the left then
touch a selection from the Logical Aux Bus list on the right to assign it.