GRASS VALLEY K2 SOLO -, Руководство по обслуживанию

Страница: 51 / 106

09 April 2010 K2 Solo Media Server Service Manual 51
Identify adapters
• If “Loopback” is installed, skip this procedure.
• If “Loopback” is not installed, continue with this procedure.
3. If you have not already done so, disable the write filter.
4. In the Windows Control Panel, open
Add Hardware
and then click
Next
.
5. Click
Yes, I have already connected the hardware
, and then click
Next
.
6. At the bottom of the list, click
Add a new hardware device
, and then click
Next
.
7. Click
Install the hardware that I manually select from a list
, and then click
Next
.
8. Click
Network adapters
, and then click
Next
.
9. In the Manufacturer box, click
Microsoft
.
10.In the Network Adapter box, click
Microsoft Loopback Adapter
, and then click
Next
.
11.Click
Next
, then
Finish
.
12.In Control Panel, go to
Network Connections
.
13. Find the connection that reports itself in the Device Name column as the loopback
adapter. Right-click on this icon and rename the connection to
Loopback
.
14. Right-click on the Loopback icon and select
Properties
.
15. Select
Internet Protocol (TCP/IP)
and click the
Properties
button.
16. Click
Use the following IP address
and set the address to
192.168.200.200
and
set the subnet mask to
255.255.255.0.
NOTE: The Microsoft Loopback Adapter must have its IP address set to
192.168.200.200. If a different IP address is used the stand-alone storage K2 Solo
Media Server can not access its own media file system.
17. Click
OK
and
Close
to exit.
18. Proceed as follows:
• If you have no additional network configuration to do, reorder adapters now.
Refer to “Reorder adapters” on page 59 . Then enable the write filter.
• If you have additional network configuration tasks to do, do not reorder adapters
now. Continue with the next task “Identify adapters” .
Identify adapters
On some K2 Solo Media Servers, it is possible that the Microsoft Windows operating
system has enumerated the “Intel® PRO/1000 PT Dual Port Server Adapter…”
names in an unpredictable sequence. You must identify adapters by their location
rather than by the enumeration assigned by the Windows operating system and verify
or modify the adapter name as necessary.
1. Open Device Manager as follows:
a. On the Windows desktop, right-click
K2 Solo Media Server
(My Computer) and
select
Manage
. The Computer Management window opens.