GRAPHTEC FC2250 Series, Руководство пользователя

Страница: 41 / 130

3-13
Chapter 3 PREPARATIONS FOR CUTTING/PLOTTING
(5) Use the [ ] or [ ] key to move the poston of the blnkng cursor, and the [ ] or [ ] key to select the value.
Setting range: 0 to 9.99 mm
Mode 2 (Crease two lines) Mode 3 (Crease three lines)
Actual data
(creasing is not performed
at the actual data position)
Spacing
Actual data
Spacing
Setting the Number of Creasing Operations
(6) Press the [F3] key to move the blnkng cursor to the poston shown n the followng screen.
FORCE OFFSET
SPEED QUALITY
MODE2 COUNT1
SPC 1.00mm ST 0.00mm
(7) Ths settng determnes how many tmes creasng should be repeated for each lne segment. Use the [ ] or [ ]
key to select the value.
Setting range: 1 to 9 (times)
Setting the Start and End Positions
(8) Press the [F4] key to move the blnkng cursor to the poston shown n the followng screen.
FORCE OFFSET
SPEED QUALITY
MODE2 COUNT1
SPC 1.00mm ST 0.00mm
(9) Ths settng determnes by what margn each end of the creasng lne falls short of the correspondng end of the actual
data lne. Use the [ ] or [ ] key to move the blnkng cursor, the [ ] or [ ] key to change the numerc value and
the [ENTER] key to confirm your selections.
Setting range: 0 to 9.99 (mm)
CP-002/003 CP-001
Actual data
Specified value
Medium
Actual data
Specified value
Medium
(10) When all the dsplayed values are correct, press the [ENTER] key . To cancel your settngs, press the [NEXT] key .
For short-line data such as circle command data, setting a large value for the ST (Start) parameter may result in creasing
not being performed.