GRAPHTEC CC300-20 Craft ROBO, Руководство пользователя

Страница: 49 / 55

4-6 CHAPTER 4. CUTTING DATA SAVED ON SD CARD
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 1. PRIOR TO USE
APPENDIX A
CH 2. CONNECTION AND PREPARATION
INDEX
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
PREFACE CONTENTS CH 1. PRIOR TO USE CH 2. CONNECTION AND PREPARATION
CH 3. CRAFT ROBO CONTROLLER CH 4. CUTTING DATA SAVED ON SD CARD APPENDIX A INDEX

Copy
■5
Go Back
You can set from 1 to 99 copies.
<The Copy function>
If you set the number of copies, the Craft ROBO cuts the same image repeatedly as shown
below.
The number of images that can be cut to the Y-direction and X-direction varies depending on
the sizes of the image and media.
Example: Copy is set to 10
• When the design orientation is landscape:
Start point
(origin)
Y-direction
X-direction
Media orientation
1 2 3 4 5
6 7 8 9 10
• When the design orientation is portrait:
Start point
(origin)
Y-direction
X-direction
5 4 3 2 1
10 9 8 7 6
Media orientation
CHECKPOINT
When cutting is complete, the number of copies returns to 1.
If you set the number of copies to more than 2, the <Start Point> setting is canceled and
cutting starts from the origin shown in the illustration above.
Registration marks are ignored when cutting using the Copy function.
If the Craft ROBO detects that the output of the images you set using the Copy function
exceeds allowable cutting area, <OFFSCALE> is displayed. If you want to cut without
changing the setting, press [ENTER], then press

or

to select <Yes> in the <Cut?>
screen, and then press [ENTER] to start cutting. If you want to cancel cutting, press
[ENTER], then

or

to select <No> in the <Cut?> screen, then modify your setting in
the <Setting> screen by following steps 2 and 3.
•
•
•
•
(4) Follow steps 12 to 16 in "Cutting with new tool conditions."