GRAPHTEC CC300-20 Craft ROBO, Руководство пользователя

Страница: 8 / 55

CHAPTER 2. CONNECTION AND PREPARATION 2-1
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 1. PRIOR TO USE
APPENDIX A
CH 2. CONNECTION AND PREPARATION
INDEX
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
PREFACE CONTENTS CH 1. PRIOR TO USE CH 2. CONNECTION AND PREPARATION
INDEX APPENDIX A CH 4. CUTTING DATA SAVED ON SD CARD CH 3. CRAFT ROBO CONTROLLER
CHAPTER 2. CONNECTION AND PREPARATION
2.1 Connecting and Turning on the Power
Use the AC adapter and the power cable provided with the Craft ROBO to connect the AC adapter jack on
the Craft ROBO to an AC outlet of the rated voltage, and then turn on the power.
CHECKPOINT
Always connect the AC adapter to the AC adapter jack before connecting the power cable to the AC
outlet.
(1) Connect the power cable (included with the AC adapter) to the AC adapter.
(2) Plug the AC adapter cable into the AC adapter jack of the Craft ROBO.
(3) Plug the other end of the power cable into the AC outlet.
(2)
(1)
(3)
(4) Press the standby switch.
When the Craft ROBO is in standby status, the LED lamp is lit green.
When the Craft ROBO is not in standby status, the LED lamp is extinguished.