GRAPHTEC CC300-20 Craft ROBO, Руководство пользователя

Страница: 18 / 55

CHAPTER 2. CONNECTION AND PREPARATION 2-11
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 1. PRIOR TO USE
APPENDIX A
CH 2. CONNECTION AND PREPARATION
INDEX
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
PREFACE CONTENTS CH 1. PRIOR TO USE CH 2. CONNECTION AND PREPARATION
INDEX APPENDIX A CH 4. CUTTING DATA SAVED ON SD CARD CH 3. CRAFT ROBO CONTROLLER
CHECKPOINT
Follow the procedure below to change the mode from Standard to Expanded or
viceversa. The default setting is "Standard" mode.
1. In the Control Panel, open "Printers" ("Printers and Faxes" for Windows XP).
2. Open "Properties" for Graphtec CC300 or CC330.
3. Click [Printing Preferences] in the "General" tab.
4. Select the desired mode in "Margins" on the "Basic Setup" tab.
(If you create the cut data using the ROBO Master or Cutting Master 2, the [Expanded]
mode is selected.)
The allowable cutting area indicated above is applicable only when the media is set
correctly.
•
•
190mm
20mm
10mm
200mm
5mm 5mm
20mm
10mm 5mm 5mm
Media
Standard mode Expanded mode
Allowable
cutting area
Allowable
cutting area