GRAPHTEC CC300-20 Craft ROBO, Руководство пользователя

Страница: 29 / 55

CHAPTER 3. CRAFT ROBO CONTROLLER 3-5
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 1. PRIOR TO USE
APPENDIX A
CH 2. CONNECTION AND PREPARATION
INDEX
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
PREFACE CONTENTS CH 1. PRIOR TO USE CH 2. CONNECTION AND PREPARATION
INDEX APPENDIX A CH 4. CUTTING DATA SAVED ON SD CARD CH 3. CRAFT ROBO CONTROLLER
Click [Install] to continue.
(4) The screen below is displayed.
Click [Install] to continue.
(5) If the screen below is displayed, click [OK] to restart your computer.
3.3 Starting up the Craft ROBO Controller
The Craft ROBO Controller can be started up from the [Start] menu on the Windows desktop or from the
Craft ROBO-compatible software such as ROBO Master.
(1) Press the Standby switch on the Craft ROBO, and check that the LED lamp is lit (green).
(2) Check that the Craft ROBO and your computer are connected by a USB cable.
Startng up from the Wndows [Start] menu
The Craft ROBO Controller can be started up from the Windows [Start] menu. To start it up, select
"Start"

"(All) Programs"

"Craft ROBO"

"Craft ROBO Controller".
CHECKPOINT
Cutting operation other than test cut cannot be done when you start the controller from
the Start menu.