INSERTING & REMOVING BATTERY
1.
Pull up and out on the end of the rubber
battery compartment flap
on the bottom
of the printer to open the
battery compartment
.
2.
Slide the
battery
into the
printer
until it snaps into place.
u
NOTE:
The
printer
automatically turns on when the
battery
is installed.
3.
Close the
battery compartment flap
.
4.
To remove the
battery,
open the
battery compartment flap
and pull gently on
the
pull tab
on the end of the
battery
until it freely slides out.
u
NOTE:
Do not remove the
pull tab
.
u
CAUTION:
Always power down the
printer
before removing the
battery
to prevent damage to the LCD.
CHARGING THE BATTERY
The
battery
is pre-charged. There is no need to charge the
battery
prior to using
the DuraLabel 2000 for the first time. When the
battery
needs to be recharged,
plug one end of the
battery charger
into the
battery
and the other end of the
charger
into an electrical outlet. Allow approximately 5 hours to fully charge.
u
NOTE:
The
printer
is not designed to operate while the battery is charging.
u
WARNING:
Always dispose of batteries properly. For more information, visit www.rbrc.org
LED STATUS
BATTERY
On ..................................................... Charging
Blinking every 2 seconds ................ Fully Charged
Blinking every 1/2 second ............. Error
Battery
Compartment
Flap
LED Window
Pull Tab
Battery
Compartment
Battery
Power Jack
Window
LED
Power
Jack
3. The BATTERY
Содержание DuraLabel 2000
Страница 55: ...NOTES 52...