17
Before fitting any rack, lay it out in front of the closed gate to see how it lines
up. start at the operator end, with the first length sitting on the operators gear
wheel, adjusting the position of the rack as you go to make sure the mounting
lugs miss the wheels. if the last length needs to be cut shorter, it must have at
least two mounting lugs attached to the gate.
this gate operator has no magnet for the open limit so the rack can go right to
the very end when the gate is open.
1) start with the first length overlapping the
gear wheel by 100mm, mark this position,
then add more lengths until the end is
reached.
step 3 - fit the raCk to the Gate
2) make sure mounting
lugs miss the wheels
3) last length of rack may need to be cut shorter,
if so it must have at least two mounting lugs on
the gate. if this isn’t possible then all the rack
may need to be moved back a bit and the first
length may also need to be cut.
4) mark on the gate where the last
length will finish (after cutting).
5) fully open the gate by hand
and using the end mark check the
rack still contacts the gear wheel
on the operator, if not it will need to
be adjusted.
Open Fully
