grandimpianti BTEL15*N4065, Руководство по программированию

Страница: 45 / 56

© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
Programming MDC
43
801293
30. Configuration “-030”
This option allows the owner to turn ON or turn OFF
preprogrammed capabilities within MDC.
How to Program Configuration
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode .
2. Press the DELICATES 30 (
∧
) or the PREWASH
(
∨
) keypad until “PrOg” appears in the Four-
Digit Display.
Figure 67
3. Press the START (enter) keypad and “-001” will
appear in the Four-Digit Display.
4. Press the DELICATES 30 (
∧
) or the PREWASH
(
∨
) keypad to scroll through the programmable
options until “-030” appears in the Four-Digit
Display.
Figure 68
5. When “-030” appears in the Four-Digit Display,
press the START (enter) keypad. A number will
appear in the Four-Digit Display. This number
corresponds to the current Configuration value.
6. Press the DELICATES 30 (
∧
) or the PREWASH
(
∨
) keypad to increase or decrease the current
value to the desired value selected from Table 2 .
7. Press the START (enter) keypad when the correct
value appears in the Four-Digit Display. The
next option will appear in the Four-Digit Display.
(On software versions less than “S003”, the first
option, “-001”, will appear in the Four-Digit
Display. On software version “S003” and higher,
“-031” will appear in the Four-Digit Display.)
NOTE: To program “-031” (Default Cycle), refer to
option 31. To program other options, refer to the
appropriate section.
How to Exit Programming Feature
1. Be sure the control shows a programmable
option, not a value.
2. While pressing and holding the NORMAL 90
keypad with one hand, press the NORMAL 60
keypad with the other hand. The control will
revert back to the previous mode of operation.
COM1R
COM35R