grandimpianti BTEL15*N4065, Руководство по программированию

Страница: 13 / 56

© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT 11
801293
Opening the Service Door
Manually programming MDC requires the user to
open and close the service door. Opening and closing
the service door trips a switch allowing access to
various programming options, diagnostics, and audit
capabilities.
The service door is located in the control panel. Refer
to
Figure 3 .
After opening and closing the service door, the
programmer has 4.25 minutes to begin programming.
If a SELECT CYCLE keypad has not been pressed in
that time, the control will revert back to the Ready
Mode.
Washers Prepped for Central Pay System
Manually programming MDC requires the user to
remove the control panel and unplug the bullet
connector located between the “white/black” and “red/
blue” wires. This will allow the user to access various
programming options, diagnostics, and audit
capabilities. Refer to
Figure 3 .
Figure 3
1 Service Door
FLW11R
FLW10R
25 25
FLW15R
1
1
COIN/CARD
STACKED WASHER AND DRYER
FLW10R
FLW11R
CENTRAL PAY WASHER
FLW15R
1
COIN/CARD FRONT CONTROL WASHER
SWD1R
1
SWD1R
CENTRAL PAY STACKED WASHER
AND DRYER