Graco SD HP Series, Инструкция по эксплуатации

Страница: 18 / 52

Installation
18 313431K
7. Run the end of hose (B), through the hose guide (G)
and then the hole (E) in reel (F
IG
. 12).
8. For air/water or oil reel, attach hose end (B) to
hose reel swivel (A). Then carefully remove
C-Clamp (D) (F
IG
. 11).
9. For grease reel, insert hose end (B) through
bracket (H). Attach hose end (B) to strain relief hose
(J).
10. Pull hose hard enough to release the latch, and
slowly allow the hose to retract.
11. Flush system.
To avoid contaminating the fluid with line-scale,
chips or other installation debris, before installing
meter or dispense valve to end of hose, flush the
equipment with a compatible solvent such as Stod-
dard solvent or mineral spirits.
a. Secure the end of the hose in a waste bucket.
b. Blow out entire lubricant supply line with air.
c. Pump solvent through line until fluid runs clear
and is debris free.
d. Pump lubricant through line until all solvent is
flushed out.
12. Position hose stop so hose extends far enough for
all operators to reach dispensing valve.
13. Insert screws through hose stop and tighten nuts to
securely hold hose stop in place.
14. Install meter or dispense valve to end of hose follow-
ing instructions provided with the dispense equip-
ment. (NOTE: If installing an enclosure around hose
reel, install the enclosure before installing dispense
valve or meter to hose end.)
15. Adjust spring tension, page 19.
F
IG
. 12
A
B
C
E
F
G
A
B
C
E
F
G
Grease reel
ti13190-2
Air/Water or Oil reel
J
H
ti13190
ti13190-3
NOTICE
Do not bypass mounting bracket H. Failure to attach
the hose through mounting bracket H can cause
decreased retraction performance.