Graco SD HP Series, Инструкция по эксплуатации

Страница: 11 / 52

Installation
313431K 11
Overhead Installations
HS Models Only
1. Reposition guide arm to position AA. See Step 2 for
HS Model Reels (above).
2. Position the hose reel so the pedestal is facing up.
3. Using the lift truck, raise the reel as close to the
mounting location as possible.
4. Bolt hose reel to its mounting. Be sure it is secure
before lowering the lift truck.
5. Connect inlet supply line to inlet hose of the reel.
See Hose Installation, page 17.
NOTE:
• None of the hose reels listed in this manual come
with a Hose Inlet Kit.
6. Flush system.
To avoid contaminating the fluid with line-scale,
chips or other installation debris, before installing
meter or dispense valve to end of hose, flush the
equipment with a compatible solvent such as Stod-
dard solvent or mineral spirits.
a. Secure the end of the hose in a waste bucket.
b. Blow out entire lubricant supply line with air.
To reduce the risk of injury, when you are mounting a
hose reel overhead, always use a lift truck.
F
IG
. 5
Incorrect
Correct
F
IG
. 6
2
3
1
5 ft (1.5m) minimum for motor oil
1
6 ft (1.9m) minimum for 1 lift
2
Center between two lifts
3
ti13351