Graco LineLazer ES 1000, Установка, Ремонт, Запчасти

Страница: 13 / 120

Battery and Charger
3A4603F Operation, Repair, Parts 13
Charging the Battery
If the battery level is below 9.7V, the on-board charger
will not be allowed to charge the battery. Charge battery
with an external charger to raise the level above 10.0V to
activate the on-board charger, or replace the battery.
Use an extension cord with an undamaged ground
contact. If an extension cord is necessary, use a 3-wire,
12 AWG (2.5 mm
2 ) minimum.
Batteries are fully charged when leaving the factory.
Due to self-discharging of the battery, charge battery
before first use. It takes ~3 hours to charge a dead
battery to 80%. It takes ~5 hours to charge a fully
depleted battery (double these times for 2 battery unit).
1. Place unit in dry, well-ventilated area and away from
flammable or combustible materials, including
paints and solvents.
2. Ensure power switch is in OFF position.
3. Plug charging cord into charging port on the unit.
Connect an extension cord, minimum 12AWG
(2.5mm
2
), to the charging cord and plug it into wall
power.
4. When power is connected the voltmeter will turn on
and the charger will immediately begin charging.
User should be able to see voltmeter start to climb
to indicate charging is occurring.
5. Battery will charge to 14.6-14.8 volts and then it will
come back down to ~13.6 volts when fully charged.
Replace and charge battery only in well-ventilated
area and away from flammable or combustible
materials, including paints and solvents.
ti30322a
ti30358a
ti30359a
ti30360a