9
10
3
Rotate the lower back support
up while holding the booster
seat until it clicks into an upright
position.
4
Align the side impact shield with
the slot of lower back support
plastics mounts, and then insert
to lock.
5
! Please choose whether to install
the side impact shield according
to the size of the car.
Height Adjustment
– for Head Support
See images
6
6
Squeeze the head support
adjustment lever while pulling
up or down on the head support
until it snaps into one of the 10
positions.
Concerns on
Installation
See images
7
-
10
Installation with
3-point-belt
See images
11
-
21
If vehicle is equipped with ISOFIX, the
vehicle lower anchor points may be
visible at the vehicle seat crease. See
your vehicle owner’s manual for exact
locations, anchor identification, and
requirements for use.
11
Place the booster in forward-
facing position on a forward
facing vehicle seat with anchors,
hook latch connectors to vehicle
anchors.
! NEVER put two latch connectors
on one vehicle ISOFIX anchor
unless specifically allowed by
the vehicle manufacturer.
12
Secure the booster firmly by
pushing it downward with
knee or hand while pulling the
adjustment belt.
13
For ease of unhooking, extend
the adjustment belt to its
maximum length while pressing
the adjustment button.
! The latch connectors can be
detached for use from the
compartment on the bottom
where it is stored.
! Pull the vehicle safety belt and
pass through the belt path,
17
and then buckle it up.
17
-3
! Could also be installed by using
3-point belt only.
(
See images
17
-
21
)
! Position shoulder belt through
the shoulder belt guide shown
in
17
-1
! DO NOT position vehicle belt
over top of the armrests. It must
pass underneath the armrests.
17
-2
! The booster can not be used if
the vehicle safety belt buckle
(female buckle end) is too long
to anchor the booster securely.
17
-4
! After your child is placed in this
booster, the safety belt must
be used correctly, and ensure
that any lap strap is worn low
down, so that the pelvis is firmly
engaged.
17
! To ensure the correct head
support height is obtained, the
bottom of the headrest MUST
be even with the top of child’s
shoulders as shown in
18
and the shoulder belt must be
positioned in the green zone as
shown in
19
! Place a booster firmly against
the back of a forward-facing
vehicle seat equipped with a
lap/shoulder belt. ! Make sure,
that the shoulder belt portion
of the vehicle belt goes straight
through the shoulder belt guide
as shown in
20
! Tighten the vehicle belt by
pulling the shoulder strap until
all belt slack is removed.
! If the belt lays across child neck,
head or face, readjust head
support height.
! Any straps holding the booster
to the vehicle should be tight
and the straps should not be
twisted.
Use Cupholders
See images
22
Detach Soft Goods
See images
23
Open 2 pairs of buttons and 6 pairs of
elastics on the back of soft goods to
remove it.
23
To refit the seat pad simply reverse
the steps above.
Care and
Maintenance
Please wash the seat cover and inner
padding with cold water under 30°C.
Do not iron the soft goods.
Do not bleach or dry clean the soft
goods.
Do not use undiluted detergents,
gasoline or other organic solvent to
wash the child restraint. It may cause
damage to the child restraint.
