Graco E-Flo iQ, Руководство по эксплуатации

Страница: 60 / 102

Troubleshooting
60 333587B
MAD_ Pump Advisory Maint. Due Pump
P_ Maintenance
due for pump The number of
pump cycles since
last reset has
exceeded the
maintenance limit
set Perform desired maintenance and reset the
pump cycles in the setup screen.
MBD_ Pump Advisory Maint. Due Driver
P_ Maintenance
due for driver The number of
driver cycles since
last reset has
exceeded the
maintenance limit
set Perform desired maintenance and reset the
driver cycles in the setup screen.
MLC_ Pump Advisory Rebuild Platen
Seals P_ Maintenance
due for platen
seals The number of
replaced drums
since last cycles
reset has exceeded
the maintenance
limit set Rebuild the platen seals if desired and reset
the platen cycles in the setup screen.
MLD_ Pump Advisory Maint. Due
Platen Valve P_ Maintenance
due for platen
valve The number of
platen valve cycles
since last reset has
exceeded the
maintenance limit
set Perform desired maintenance and reset the
platen valve cycles in the setup screen.
MED_ Pump Advisory Maint. Due
Dispense Valve
P_ Maintenance
due for
dispense valve The number of
dispense valve
cycles since last
reset has exceeded
the maintenance
limit set Perform desired maintenance and reset the
dispense valve cycles in the setup screen.
MG2_ Pump Advisory Low Filter
Pressure P_ Low filter
pressure drop
detected The filter has an
opening in it Replace the fluid filter.
MG3_ Pump Advisory High Filter
Pressure P_ High filter
pressure drop
detected There is a clog in
the manifold Clean out the manifold to reduce the
pressure.
P1C_
P2C_ Pump Alarm or
Deviation
(user
selectable) Low Pressure P_ Measured
outlet pressure
less than
desired outlet
pressure minus
tolerance Incorrect pressure
tolerance Enter correct pressure tolerance percentage
in setup screen.
Failed pressure
transducer Check transducer, replace if failed.
No or insufficient
material flow Increase material flow.
Restrictor not
closed enough Slowly close restrictor to build pressure.
P4C_
P3C_ Pump Alarm or
Deviation
(user
selectable) High Pressure P_ Measured
outlet pressure
greater than
desired outlet
pressure plus
tolerance Incorrect pressure
tolerance Enter correct pressure tolerance percentage
in setup screen.
Failed pressure
transducer Check transducer, replace if failed.
Clog in fluid supply
system Check hose and other components in fluid
supply system for clogs.
P6D_ Pump Deviation Outlet Pressure
Sensor P_
Outlet pressure
transducer not
connected The outlet pressure
transducer is not
connected or faulty Verify outlet pressure transducer is installed
and/or connected correctly. Replace if
necessary.
Error Location Type Error Name
Error
Description Cause
Solution