Remote DataTrak Operation
334222B
11
Remote DataTrak Operation
Startup
1. Turn the main air ball valve off before turning the
remote DataTrak power on.
2. Turn on the remote DataTrak system by plugging
the AC adapter into a 100-240V power supply.
3. The Splash screen (F
. 3) will flash on while the
progress bar fills from left to right. It will then go
directly to Run mode (F
4. Follow the Start and Adjust Pump procedure in the
pump manual.
Run Mode
The Run Mode screen displays the resettable job total
counter (JT), maintenance counter (MC), cycle/flow rate
(CF), and the remaining volume in the drum (DV) in both
numeric and icon versions.
NOTE:
All items are displayed using the defined volume
units (VU).
Key Functions When in Run Mode
1. To enter Prime Mode, press and release
.
2. To enter Setup Mode (page 12), press and hold
for 3 seconds.
3. To enter Diagnostic Mode (page 15), press and
release
. The system will enter Diagnostic Mode
only if there are active warnings/alarms.
4. To reset the job total counter, press and hold
from Run Mode for 3 seconds.
NOTICE
To prevent damage to soft key buttons, do not press
the buttons with sharp objects such as pens, plastic
cards, or fingernails.
NOTICE
If the motor air valve is not turned off, the air supply to
the motor will automatically turn on via activation of
the air solenoid when the display changes from the
Splash screen to Run mode.
F
IG
. 3: Splash Screen
F
IG
. 4: Run Mode Screen
CF
MC
JT
DV
