Graco Advanjet Diaphragm-Jet HV-2000, Настройка и эксплуатация

Страница: 15 / 60

3A5856A Advanjet HV-2000C Jet Controller Setup and Operation Page 15 of 60
3.2 Temperature Controller (Continued)
To turn OFF the heater:

Press until the
Run-Stop screen is
displayed (
r-S ).

Use the

keys to
select the Stop setting
to turn OFF the heater.

Press the key to save the change. Now the heater is turned OFF.

Press the key again to return to the main screen display
To change the Set Value (SV)
temperature, use the

keys
to increase/decrease the value.
For example, to change SV
from 20 to 45 degrees, use the

key to increase the SV value
to 45, and then press to
save the change.
Technical specifications of the heater can be found in Appendix 2: Temperature
Controller Factory Settings.
3.3 Trigger Button and LED
Pressing the
Trigger Button immediately executes
the current recipe (recipe # and parameters)
displayed on the LCD screen. If multiple drops were
specified in the recipe, multiple drops will be
dispensed.
The
Trigger Output LED is on when the Jet is firing
to verify a signal was sent to the Jet. The light is off
when the Jet is in idle state.
Figure 3-8: Turn OFF the Heater
Figure 3-9: Press

to increase the SV value to 45,
then press to save the change
Figure 3-10:
Trigger Button and Output LED