Shutdown and Cleaning
332119E
15
Shutdown and Cleaning
Flushing Field Marker
1. Perform
Pressure Relief Procedure
, page 10.
2. Empty the paint hopper (S), see page 12.
3. Remove paint hopper screen and clean
4. Clean inside of paint hopper with water.
Optional:
Tilt
paint hopper back and spray inside with water.
5. Fill paint hopper with 1/2 gallon (2 liters) water.
6. Put prime/spray valve (D) UP to clean prime hose.
7. Push spray button (A) to pump water through prime
hose. Pump until water is clear.
8. Push spray button to stop pumping water through
prime hose.
9. Put prime/spray valve (D) DOWN to spray position.
10. Push spray button to spray water through tip. Spray
until water is clear.
11. Push spray button to stop spraying water through tip.
12. Empty the paint hopper, see page 12.
13. Repeat steps 5-10 until water runs clear.
14. Put prime/spray valve (D) UP to release pressure.
15. Remove and clean filter, page 11.
NOTICE
Failure to properly clean field marker after each use will
result in hardened materials, damage to the field marker,
and the warranty will no longer be valid. Do not store
solvents in field marker. Always flush with Graco Pump
Armor prior to storage.
Use only water-based materials.
Do not use materials
which state “FLAMMABLE” on the packaging. For more
information about your material, request MSDS from dis-
tributor or retailer.
Do not operate or spray near children. Do not aim the
field marker at, or spray any person or animal. Keep
hands and other body parts away from the discharge.
For example, do not try to stop the paint flow with any
part of the body.
This field marker builds up an internal pressure of 1200
psi (8.3 MPa, 83 bar) during use. Follow this
Pressure
Relief Procedure
whenever you stop spraying and
before cleaning, checking, servicing, or transporting
equipment to prevent serious injury.
ti20183a
ti20193a
S
ti20211a
ti20212a
A
ti20184a
D
ti20183a
D
