Starting a New Job
14
332119E
Adjusting Line Width
With Shields
1. Perform
Pressure Relief Procedure
, page 10.
2. Remove height adjustment mount (J) and material
dispenser arm assembly.
3. Install inner spray shield assembly (M) by collapsing
spring and sliding shield onto horizontal D-bar.
4. Install height adjustment mount (J) and material dis-
penser arm assembly
5. Install outer spray shield assembly (M) by collapsing
spring and sliding shield onto horizontal D-bar.
6. Adjust shields to the desired line width. Spray tip
should be centered between shields. Spray pattern
should touch shields just above the bottom of the
shields.
Without Shields
1. Perform
Pressure Relief Procedure
, page 10.
2. Move vertical material dispenser bar holder to
outside position.
3. Adjust height of tip to adjust line width (raising tip
height will create wider lines).
NOTE:
Different tip sizes are available for lines
greater than 6 in. (15 cm) wide. Use Graco part
number LL5417 for wider lines.
ti20183a
ti21320a
J
ti21319a
M
ti21321a
J
ti20187a
M
ti20187a
ti20189a
