6) SERVICE
a. Have your power tool serviced by a qualified
repair person using only identical
replacement parts. This will ensure that the
safety of the power tool is maintained.
b. Never service a damaged battery. Service of
battery should only be performed by the
manufacturer or authorized service
providers.
VACUUM LIFTING DEVICE SAFETY
WARNINGS / INSTRUCTIONS
a. Do not deliberately try to rip the load off
with extreme force. There is a risk of the
load crushing feet and hands and damaging
the object and tool.
b. Do not lift objects weighing more than 170
kg (375 lbs). There is a risk the weight can fall
off.
c. Risk of load crushing feet and hands and
damaging the object and tool. Do not shake
the tool while lifting, moving and placing
objects. Do not swing or shake the load
while lifting, moving and placing objects. Do
not use the tool when the seal is worn out.
Lift and carry the load with uniform speed
without sudden sharp and strong
movements.
d. Do not use the tool while the battery is low.
There is a risk of injury and damage to the
materials being lifted.
e. If the sealing force begins to noticeably
decrease while the battery is fully charged,
check the rubber foam seal for wear and
tear or damage. Do not attempt to lift
anything with the tool until you have
replaced the seal.
f. Use caution when lifting large thin flexible
sheets, like drywall, cardboard, plastic,
plywood, thin sheet metal etc. Thin sheets
bend and flex and can unexpectedly change
curvature above their limit and detach.
g. Do not attach the tool to surfaces with
visible puddles of water. Internal
components are not waterproof. If water is
sucked into the air ducts it can cause
permanent damage to the tool. The Nemo
GRABO® is not waterproof and therefore
extreme caution should be taken when
using it in the rain or wet conditions.
h. Do not drop the tool from heights above 1.5
meter above the ground (chest level). If
dropped by accident, inspect the seal side
lips for damage.
i. Do not place heavy objects on top of the
tool.
j. To avoid overheating, do not cover the tool.
k. Ensure the switch is in the off-position
before transporting the tool and when in
storage. Be mindful that the tool is not
switched on accidently.
l.
NOTICE:
Due to the high pressure that is
created with the Nemo GRABO® we
strongly recommend that you do not
attempt to attach the Nemo GRABO® to
glass thinner than 6mm thick. Damage can
occur to glass that is thinner than 6mm
thick.
! WARNING:
Weight may drop without
warning if the safety precautions are not
kept! The Nemo GRABO® creates a strong
vacuum. In case the seal is broken or the
allowed weight is exceeded or any other
factor that causes the negative pressure to
release spontaneously, this kind of failure
will happen very suddenly and absolutely
without any sensory indication or warning.
You will not notice the weight detaching
and there will be no possibility to stop or
catch it. This is very dangerous, especially
with heavy loads. Therefore all safety
precautions should be kept to the
maximum.
15
NEMO GRABO® | Operator’s manual
Содержание NEMO
