Device description
Page 16
Drum Magnet (Re-)Adjusting the magnet segment
We have already mounted the magnet segment in the correct position. It will therefore probably not be
necessary to re-adjust it. If however you have a bad separation because all Fe parts fall down before
they are above the Fe outlet, then you will have to rotate the magnet segment to the correct position.
This can be done as follows :
1. Loosen the clamp bush bolts. The magnet is mounted on the shaft that is now loosened. Rotate the
magnet segment to the desired position by rotating the shaft.
2. For this purpose you can use the aid of the adjustment wrench section on the shaft on the non-
motor side.
3. Retighten the clamp bush bolts.
False positioning of the magnet segment will cause bad separation.
Therefore special attention for the positioning is very important!
Clamp bush
bolts
36 mm
segment
for wrench
Magnet
segment
Separation
Splitter
