GORMAN-RUPP PUMPS SE Series, Инструкция по установке и эксплуатации

Страница: 8 / 14

SE SERIES
OM-06617
OPERATION 6
OPERATION
Review all SAFETY information in Section A.
Follow the instructions on all tags, labels and
decals attached to the pump.
PUMP OPERATION
Do not operate this pump where explo­
sive vapors or flammable material exist.
Death or serious injury will result.
This pump is designed to handle dirty
water that does not contain large en­
trained solids. It is not designed to
pump volatile, flammable or corrosive
materials. Do not attempt to pump any
liquids which may damage the pump or
endanger personnel as a result of pump
failure.
Install the pump and piping as described in IN­
STALLATION .
Operation of Pumps Without Integral Float
System
Each pump is provided with a 50‐foot (15 meter)
power cable.
Never splice the power cable due to
safety and warranty considerations.
Never attempt to alter the length or re­
pair any power cable with a splice. The
pump motor and cable must be com­
pletely waterproof. Damage to the pump
or personal injury may result from alter­
ations.
Always keep the plug end dry.
Figure 1. Always Keep Plug End Dry
For manual operation, simply plug the power cable
into any 115 volt
grounded receptacle. It is strong­
ly recommended that a Ground Fault Interrupter
(GFI) type receptacle (or equivalent) be used (see
Figure 2).
Always use a three‐prong grounded re­
ceptacle. It is strongly recommended
that a Ground Fault Interrupter (GFI)
type receptacle (or equivalent) be used.
Figure 2. Always Use a Grounded Receptacle
Automatic Operation (Ball Type Float System)
Some units are equipped for automatic operation
with either a vertical slide or a ball type float system.
For automatic operation with a ball type float, al­
ways make sure the float hangs free. It should not
come into contact with the bottom or side of the
sump.