Gorilla Playsets 1500KWR, Руководство пользователя

Страница: 114 / 188

ROOF SUPPORTS
1 X 4 X 30-1/2"
ROOF STARTER
DETAIL A
#8 X 1-1/2"
WOOD SCREW
PLACE A CLOSE
TOGETHER AS POSSIBLE
WITHOUT THE STARTERS
OVERLAPING.
A
STEP 54: UPPER LEVEL ROOF
1: PLACE THE 1 X 4 X 30-1/2" GROOVE-ONLY ROOF STARTER BOARDS AT THE PEAK OF THE ROOF.
THE HOLES IN THE ROOF STARTERS SHOULD BE APPROXIMATELY CENTERED (SEE BELOW) ON THE
ROOF SUPPORTS, AND THE FLAT ENDS OF THE ROOF STARTERS SHOULD BE PLACED AS CLOSE TO
EACH OTHER AS POSSIBLE WITHOUT THE BOARDS OVERLAPPING.
2: FASTEN THE ROOF STARTER BOARDS TO THE ROOF SUPPORTS WITH #8 X 1-1/2" WOOD SCREWS.
MEASURE DIM A ACROSS THE BOTTOM OF THE ROOF SUPPORTS NEAR THE CORNER POSTS. WHEN
ATTACHING THE ROOF STARTERS DIM B AT THE ROOF PEAK SHOULD MATCH DIM A. THIS WILL
MAKE THE ROOF SUPPORTS PARALLEL TO EACH OTHER. DUE TO WOOD MILLING VARIATIONS
YOUR HOLES IN THE ROOF STARTERS WILL EITHER BE CENTERED ON THE ROOF SUPPORTS OR THEY
WILL BE OFFSET TOWARDS THE INSIDE OF THE ROOF SUPPORTS SLIGHTLY. SUBTRACT DIM A FROM
30-1/2" AND THEN DIVIDE THIS NUMBER BY 2. THIS WILL GIVE YOU THE OVERHANG FOR EACH
SIDE. USE THE OVERHANG NUMBER ON EACH SIDE TO KEEP YOUR ROOF SUPPORTS PARALLEL.
SUPPORT AT THE PEAK
SUPPORT ATTACHED TO
OF THE ROOF.
TOP OF ROOF
ROOF STARTER
ROOF SUPPORT
ROOF SUPPORT
THE CORNER POST.
BOTTOM OF ROOF
EXAMPLE: 30-1/2" MINUS 23-5/8"
EQUALS 6-7/8". 6-7/8" DIVIDED BY
2 EQUALS 3-7/16" OVERHANG
PER SIDE.
OVERHANG OVERHANG
DIM B
" ROOF STARTER LENGTH
2
" EXAMPLE DIMENSION
30 1
23 58
DIM A
106