EN 19
surface may also be damaged by aggressive spray
cleaners
and
unsuitable
liquid
cleaners.
Signage may be worn when using aggressive or
abrasive cleaners or cookware with coarse or
damaged bottom.
Use a damp soft cloth to remove minor impurities.
Then, wipe the surface dry.
Remove water stains with a mild solution of vinegar.
However, do not use this solution to wipe the frame
(only with some models) as it may lose its sheen. Do
not use aggressive spray cleaners or descaling
agents.
Use special glass ceramic cleaners for stubborn dirt.
Observe the manufacturer's instructions. Be sure to
thoroughly remove any cleaner residues after the
cleaning process as they may damage the glass
ceramic surface when the cooking zones heat up.
Remove stubborn and burnt residues with a scraper.
Be careful when handling the scraper to prevent
injury.
Only use the scraper when dirt cannot be
removed with a wet cloth or special cleaners for glass
ceramic surfaces.
Hold the scraper at the correct angle (45° to 60°).
Gently press the scraper against the glass and slide
it over the signage to remove the dirt. Make sure the
plastic handle of the scraper (in some models) does
not come into contact with a hot cooking zone.
Do not press the scraper perpendicularly
against the glass and do not scratch the hob surface
with its tip or blade.
Immediately remove any sugar or sugar-laden food
from the glass ceramic hob using a scraper, even if
the hob is still hot, as sugar may permanently damage
the glass ceramic surface.
Discolouration of the glass ceramic surface
does not affect the operation or stability of the
surface. Such discolouration is most commonly a
result of food residues burnt onto the surface, or it
may be caused by some cookware materials (such as
aluminium or copper). Such discolouration is very
difficult to remove entirely. Note: Discolouration and
similar flaws only affect the appearance of the hob
and do not directly affect its function. Removing such
flaws shall not be covered by the warranty.
OVEN
Clean the oven walls with a damp sponge and
detergent. To clean stubborn stains burned into the
oven wall use a special detergent for enamel. After
cleaning carefully wipe the oven dry. Clean the oven
only when it is completely cold. Never use abrasive
agents, because they will scratch enameled surface.
Wash the oven utensils with a sponge and detergent.
You can also use special detergents to remove rough
stains or burns.
USING THE
„AQUA CLEAN“ FUNCTION
Turn the COOKING SYSTEM SELECTOR KNOB to
position AQUA CLEAN
. Set the TEMPERATURE
KNOB to 70°C.
Pour 0,6 l water into a baking tray and place it in the
lower guide.
After 30 minutes, food residues on the oven enamel
walls will have softened and they will be easy to clean
with a damp cloth.
Use the
“AQUA CLEAN“
system when
the oven has fully cooled down.
REMOVING AND CLEANING WIRE AND
TELESCOPIC EXTENDIBLE GUIDES
Only use conventional cleaners to clean the guides.
Hold the guides by the bottom side and pull them
towards the center of the oven cavity.
Remove them from the openings at the top.
Do not clean the extendible guides in the
dishwasher.
INSTALLING THE CATALYTIC INSERTS
Only use conventional cleaners to clean the guides.
Remove the wire guides or extendible guides.
(depending on the model)
