EN 20
Mount catalytic inserts onto the wire guides. The
upper part of the guides must be mounted into the
upper openings "A" in the catalytic inserts.
Place the wire guides with the catalytic inserts on the
upper openings in the side walls of the oven “A“.
Press them into the snap lock at the bottom “B“.
Do not wash the catalytic inserts in the
dishwasher.
REPLACING THE BULB
The bulb is a consumable and therefore not covered
by warranty. Before changing the bulb, remove the
trays, the grid, and the guides.
Disconnect the appliance from the power mains!
Halogen lamp: G9, 230 V, 25 W. (Regular bulb E14,
230 V, 25 W - depending on the model.)
Undo the bulb cover and pull out or undo the bulb.
Use protection to avoid burns
.
COMFORT DOOR CLOSING
(depending on the model)
Cookers are equipped with new secure door hinges
COMFORT. These special hinges guarantee very
quiet and gentle closing of the oven door.
If the force applied to close the door is
too strong, the efficiency of the system
can be reduced or the system's safety
can be affected.
DOOR LOCK
(depending on the model)
Open the door lock by gently pushing it to the right
with your thumb while simultaneously pulling the door
outwards.
When the oven door is closed, the door
lock automatically returns to the initial
position.
REMOVING AND REPLACING THE OVEN
DOOR
(depending on the model)
1. Open the oven door (up to end position).
2. Rotate the flaps of door hinges (in case of
conventional closing).
At COMFORT soft closing system, rotate the flaps
by 90°.
3. Slowly close the oven door until the flaps fit
together with the hinges in the side laths of the
door. At t
he angle of 15° (regarding to the closed
door position), slightly close the door and pull it out
from both hinges of the appliance.
Before replacing the door, always check
that the hinge flaps are correctly placed
in the side laths of the door. You prevent
the sudden closing of the hinge so,
which is connected to a strong spring.
The releasing of flap causes the
damaging of door and a risk of injury.
