GVC-2200-V Operation & Maintenance Manual
In minus or low temperatures pre-steam the glass surface before starting to clean it.
Always use low steam.
Application A (with glass cleaner)
First only use the steam (on low pressure) on the glass surface. Then switch off the
steam and wipe the condensed water with the glass cleaner wiper (without pressure)
from the top to the bottom of the glass surface.
Application B (with brush)
Place a small cloth over the brush. Now wipe the surface with the brush a few times
using steam. Switch on the Vacuum and wipe the surface with the glass cleaner using
vertical strokes from the top to the bottom of the glass surface.
6.3 Operating the Vacuum
The Vacuum is operated by means of the red trigger switch located on the pistol grip.
6.4 Specialty
cleaning
For cleaning ingrained dirt, or joints, corners and other places that are difficult to reach,
use the hooked nozzle. Slant the nozzle angle a little on the area to be cleaned so that
the pressure and steam work together to lift and remove the grease and dirt.
Clean with gentle movements at about 1.5 inches (without the small round brush) above
the surface. The small round brush needs direct contact.
Heavily soiled surfaces can be pre-treated; spray cleanser by holding the cleanser
switch down before using steam. A ‘hot water mix’ function is also available by holding
the cleanser switch down while the steam switch is operated.
7. Maintenance
7.1 Maintenance
requirement
a.
Do not expose to freezing temperatures. Only use clean tap water to refill the
boiler (do not use distilled water).
b.
Clean regularly with a damp cloth. Occasionally, the high-grade steel cabinet may
be rubbed with a little mineral oil or stainless steel polish to maintain its polished-
steel finish.
c.
Should the
GVC-2200-V
require servicing, this must be conducted by Authorized
personnel only. Do not dismantle or undertake procedures not described in this
manual. Such action voids the warranty. Notify all service requirements to
Goodway’s customer service.
7.2
Descaling the GVC-2200-V
The boiler requires descaling after every 200 hours use (approx. 2 months typical
usage) to maintain optimal operation. Please contact Goodway’s customer service.
Only Authorized and trained persons must undertake descaling procedures. For
this reason the descaling procedures have been removed from this version of the
Manual.
GVC-2200-VVAC
Page 12 of 16
August 22, 2002
