106
Avoid placing the monitor near sources of heat, in
dusty locations or smoky environments.
To install the monitor directly over the wall, drill two
holes of Ø6mm and use the supplied screws.
The upper part of the monitor connection block must
placed at 1.60m height. The minimum distance
between the monitor connection block and th
object must be 5cm.
be
e
closest
Place the monitor at right angles to the
connection block and align the attaching
holes of the monitor with the attachment
hooks of the connection block, as it is
shown on the drawing.
Lock out the monitor. Press the right side till
the attachment clip locks the monitor firmly.
To disassemble the monitor from the connector,
use a plain screwdriver to release the attachment
clip. Remove the monitor from the connection
block, with special attention do not falls.
F
ix the monitor connection block to the wall.
F
ix the monitor.
MONITOR
INSTALLATION
105
The '+' and ' ' terminals are duplicated to facilitate cascade installation of parallel monitors
or telephones. If the first monitor is not placed on the connection block, cascade units
will not be powered.
-
D
escription of the RCTK monitor connector.
a.
(x6).
b.
(x2).
c.
.
d.
.
e.
.
f.
:
Wall attachment holes
Monitor attachment hooks
Vertical wiring input
Attachment clip
Wiring input hole
Installation terminals
Positive, ground.
video signal MP input.
video signal VP input.
audio and digital communication.
uxiliary call repeater output.
a
+,
–
:
Vi + / MP:
Vi
–
/ VP :
A/D :
SA :
MONITOR CONNECTOR DESCRIPTION
a
a
b
b
c
f
e
d
