Popcorn Topping Dispenser
and Base
Model Series 2396 and 2495
Page 14
gmpopcorn.com
Units with a Photo-eye
1.
Set Heat Switch to HEAT ONLY for 30 minutes to allow topping to preheat
—
pump is
deactivated in this position.
2.
After topping is warmed, set Power Switch to HEAT & PUMP.
3.
Set Timed Switch to TIMED or NOT TIMED dispense mode.
4.
Note:
To switch between modes, power the unit OFF for the mode change to take effect.
5.
Use Auto or Manual Dispense Mode shown below.
Auto-Dispense Mode
:
1.
Place popcorn about
5”
(13 cm) under sensor.
2.
Sensor will auto-detect popcorn and dispense
topping (sensor must see product for 0.5 sec. to
begin dispensing).
Note:
A slight delay is required after popcorn is
removed for the sensor to reactivate.
To adjust the dispense settings, reference
Adjusting Dispense Settings section.
Manual Dispense Mode:
1.
Place popcorn about
5”
(13 cm) under nozzle.
2.
Press and hold a dispense button for desired
amount of topping.
Note:
If button is released before desired
amount is dispensed, remove popcorn
and wait 2 sec., then repeat step 2.
To adjust the dispense speed, reference
Adjusting Dispense Settings section.
3.
Release button to stop dispensing.
Sensor
Indicator
Beam
