Go Power DOMETIC GP-ICR-50, Руководство пользователя

Страница: 5 / 34

gpelectric.com | [page 5]
PERSONAL SAFETY
WARNING!
Personal Injury
Use safe lifting techniques when lifting this equipment as recommended by
the Occupational Safety and Health Association (OSHA) or other local codes.
Use standard safety equipment when working on this equipment, such as
safety glasses, ear protection, steel-toed safety boots, safety hard hats, etc.
Use standard safety practices when working with electrical equipment.
(Remove all jewelry, use insulated tools, wear cotton clothing, etc.)
Never work alone when installing or servicing this equipment. Have someone
nearby that can assist if necessary.
Do not touch the Inverter / Charger during operation. The temperature of
some parts of the inverter may exceed 60° during operation. Let it cool for at
least 5 minutes after shutdown before touching it.
Ensure that children, pets, and other animals are kept away from the inverter,
solar arrays, battery bank, and utility grid components.
If the equipment is used in a manner not specified by the manufacturer, the
protection provided by the equipment may be impaired.
EQUIPMENT SAFETY
WARNING!
Lethal Voltage
Review the system configuration to identify all possible sources of energy.
Ensure ALL sources of power are disconnected before performing any
installation or maintenance on this equipment. Confirm that the terminals are
de-energized using a validated voltmeter (rated for a minimum 1000 VAC and
1000 VDC) to verify the de energized condition.
Do not perform any servicing other than that specified in the installation
instructions unless qualified to do so, or have been instructed to do so by
Go
Power! Technical Support personnel.
To avoid electric shock, disconnect the DC input and AC input of the inverter at
least 5 minutes before performing any installation or maintenance.
Do not tighten the AC and DC terminals or pull on the AC and DC wiring when
the inverter is running.
WARNING!
Fire Hazard
Do not keep combustible or flammable materials in the same room with the
equipment. Some products contain relays with moving parts and are not
ignition-protected.
Ensure AC, DC, and ground cable sizes conform to local codes. See product
manuals for minimum size requirements.
Ensure all conductors are in good condition.
Do not operate the unit with damaged or substandard cabling.
GENERAL INFORMATION