17
16
How to Use the Main Devices
This is used to perforate the end of films so the laminated papers can be
easily cut. As you can see in the picture, put the perforator roughly 1~3 mm
inside
from the end of the film. Take the bolt which is used to adjust the height of
perforator,
and put pressure on the paper hard enough to perforate.
▶ Perforator Control
Notice
In case of initial loading condition or moving the perforator right & left, please
loosen the bolt so the blade or roller is kept undamaged
This is used to keep each page of paper apart and to prevent films from
being torn out. Place it that it is moderately bent, so the papers do not stick out
and neatly cut. You need to adjust the angle of the roller so the paper does not
be folded.
Notice
If the cutting sub roller is set unproperly, the papers can be folded while
laminating.
▶ Bursting Sub Roller
How to Use the Main Devices
This is used to sense papers when the buster is working.
It must be kept clean for optimal performance.
▶ Paper Sensor
his is teflon coated roller and temperature can be controlled by temp sensor.
It can be set from 0℃ to 150℃, but generally set 100℃.
▶ Laminating Roller
This is used to sense papers when the buster is working.
It must be kept clean for optimal performance.
▶ Roller Temperature Sensor
This is used to cut the laminated papers.
If you press the "Bursting start" switch, the roller
moves up and down and starts bursting.
▶ Bursting Roller
This is equipped for safety of operator.
Do not disassemble voluntarily.
▶ Pulling Roller Cover
This is used to operate the bursting roller. If you press the switch,
the roller starts working automatically according to the length of
the paper set on the display panel of SurelamPro-540HR.
▶ BURSTING STARTER
This is used to hang a paper stacker.
It is located on either side.
▶ Paper Stacker Hanger
With the stacker, laminated papers get easier to be arranged.
Adjust a stacker guide to match the length and width of the papers.
▶ Paper Stacker Guide
Notice
The roller revolves at high speed. Please keep your fingers and
clothing away from any moving parts.
