13
12
▶ What is JOB function
It memorizes user's frequently using job condition to memory and gets rid of uneasiness of
button control to set job condition every time when the machine is used.
It saves 9 kinds of different machine conditions from JOB1 to JOB9.
▶ Job Condition Storage Position Setting Button(JOB Button)
Button for setting JOB position from JOB1 to JOB9
▶ Job Condition Saving
1) Select the number by using JOB Button.
2) Set the Roller Speed you want to save by using Roller Temp. Setting Button.
3) If the temp. and speed are reset, the setting value will be blinking for 2 secs and automatically saved
in the memory.
▶ TIPS
When temp and speed setting are changed, the changed number and presently marked JOB number
twinkles for 2second. This is not only for checking if changed contents is right but also for questioning
about saving changed contents in presently displayed JOB.
▶ Power Save/Stand-by Mode(AUTO-OFF)
Automatic power breaking function for accident prevention and power save by controlling roller temp.
lower than 80 or power breaking when the machine is left not operated for a long time.
▶Power Save Mode
How to Use the Main Devices
▶ Power S/W
To supply or to cut the Power to the machine.
Press "-" for Power ON and press "0" for Power OFF.
▶ Power Cord
To connect the power to the machine.
▶ Circuit Breaker
To cut the Power automatically if the machine has overload or
overcurrent.If this Circuit Breaker is activated, the machine has to be
cooled down and press the Button of the Breaker.* If this Breaker is
activated more than 2 times, please contact to the supplier.
▶ Fuse
To protect the Electrical / Electronical Circuits from the overload in the
machine.To replace the fuse, it has to be pressed & turned to the
counterclockwise direction to pull it out.Please check the fuse status
and replace it.
▶ Emergency S/W
Press it for an emergency status is occurred while lamination.
Press to stop the Motor (Roller). In order back to normal status, rotate
the S/W as to the direction on the S/W.
▶ Support Roller
To spread the films to the Roller. Please make the film web pass through
this support roller..
▶ Paper Guide
To feed the substrates exactly.
Fix the film & substrate feeding position.
▶ Front Plate Safety Lever
For operator's safety.
The lever is available to be moved to the Right / Left directions.
To install the Front Plate, pull the lever to the right and place it.
After the plate is installed, release the lever.
* If the Lever would not be fixed at the Front Fixing hole, the Roller
would not be working.
WARNING
While the Fuse is checked & replaced, the
Power Cord has to be unplugged.
Otherwise, this will be caused by electrical
shock.
기If the machine is not used for more than 2 hours, the microprocessor embeded in the machine keeps the
roller temperature under 80.(If set temp. is lower than 80, it will be controlled by decreasing to 0 ).At this moment
power mode display lamp(AUTO-OFF) is turned on and READY or WAIT display is erased.And then after 1
hour, power save mode display lamp(AUTO-OFF) will twinkle and power will be completely off.Power save
mode release in the above two case is available only by pressing "Operation /Stop Button" and all status return
to former state before power save mode when power save mode is released.
Support Roller
PaperGuid
e
Front Plate Safety Lever
▶Former state before setting
power save mode
▶Setting power save mode
▶Setting Stand-by(safety)
mode
▶Releasing power
save/stand-by mode
EMERGENCY SWITCH
POWER SWITH
CIRCUIT BREAKER
FUSE
POWER CORD
