11
10
Funtion of Display & Button
▶Set Speed Display Window/ Both Side or Single Side Laminating Display Window
It displays roller revolution speed from 1 to 9 and can be changed by "Speed set button".
If "SPEED" is blinking, it means Single Side Lamination & if "SPEED" is not blinking, it shows Both
Side Lamination.
▶ Job Condition Storage Position Display Window
It can store 9 kinds of different job conditions from 1 to 9. Displayed number means a step of job
which stores current roller temperature and revolution speed. Job changing can be made through
job change button(Job condition storage position setting button).
▶ Job Display Window
"READY" means roller temperature arrived to set temperature. Start lamination when "READY"
displays.
▶Roller Heating Display Window
"WAIT" means roller temperature is not suitable(low temp.) than set temperature.
Temperature must be low if you start lamination when "WAIT" displays.
If "WAIT" is blinking, roller temperature is higher than set tempterature.
Temperature must be high if you start lamination while "WAIT" is blinking.
▶ Power Save Mode Display Window
"AUTO-OFF" displays the machine is in power save mode.
This machine has safe/power save function which shuts off its power for safe and power saving
when it is not used for a long time.
▶ Cutting Length Display Window
It shows the time when the cutting roller starts. The setting range of paper cutting is "210~1100".
Set the value according to the real paper length.
▶ "BURSTING STARTER
Bursting Starter Button is for Cutting Roller Operation. Pressing Button makes the Cutting Roller start
to work. The cutting roller works in accordance with Paper Length on Paper Length Window.
Refer to the Function of the Button for Paper Cutting Timing Setting.
Reference
Please operate after Test Lamination Process (Refer to Laminating Sheet))
▶ Speed Setting Button
It sets revolution speed of rollers. Roller revolution speed can be controlled from 1 to 9 step.
▶ Paper Length Setting Button
Button for Paper Length Setting.
Paper Length shows the cutting timing of the cutting roller. Setting Range for cutting timing is 210~1100.
Setting value should be same to Real Paper Length.
▶Operation /Stop Button
It turn rollers and stop revolution of rollers. Pressing STOP button makes turning roller stop.
Pressing RUN button makes the roller turn by set speed.
▶ Roller Reverse Button
It reverses rollers. While REV is being pressed, roller will reverse and beep sound can be heard while
number in speed display window is blinking. This sound is made during roller reverses and Sound
will stop once reversing ends.
▶ Current Temperature Checking Button
Pressing Current temp. checking button "MEAS" makes Current temp. of Up/Lower roller be appeared
twinkling on display window. This is for easy identification from set temp and the letter will be displayed
when the button is released.
▶ Cooling Motor Operation Button
Button for running cooling motor. Single pressing FAN button makes cooling motor runs and second
pressing makes it stop.
Cooling motor operation is required to prevent temp. raising of rear hot roller and to prevent wrinkle
status on the laminated products durling mass lamination.
▶ Photo Safety Sensor Display Window
It is displayed when the Photo Safety Sensor starts to work.
▶Emergency Switch Display Window
It is displayed when the Emergency Switch is pressed during the roller operation.
▶ Both Side Lamination Setting Window
It is displayed when the machine is set for Both Side Lamination.
▶Single Side Lamiantion Setting Window
It is displayed when the machine is set for Single Side Lamination.
▶Temp. Setting Button
Button for roller temperature. Roller temperature setting scope is min. 0 to max. 150 .
TOP TEMP: Upper Hot Roller Temperature Button
BOTTOM TEMP: Lower Hot Roller Temperature Button
HRS.RUN
▶Motor Display Window
It is displayed when the motor is working. When the motor is working, the letter is blinking.
