User Mode Setup
1. Turn on the transmitter.
2. Connect the power battery, and switch on the ESC.
3. If all connections are correctly completed, the motor should beep depending on the throttle stick
location.
Do, Re ~~ Do, Re, Mi
: If the stick is at the neutral position,
Do, Re ~~
: If the stick is at other position instead of neutral position.
4. If you press and hold the setup button for over 1 second, the Green LED should flash for 2 seconds
then the red LED should immediately flash. At this time, detach your hand from the button, the motor
should beep (Mi, Re, Do, Re, Mi sound), the red LED should flash once constantly to indicate that the
ESC is now in the User mode setting.
Flashing repeatedly once enters the Motor type setting. 18 different program features can be set in this
controllers as below.
In the programmable mode, if the setup button is shortly pressed and detached, it comes out of the
programmable mode, the ESC is ready to be used.
1. Select Motor Type
2. Battery Type
3. Cut Off Voltage
4. Power Curve
5. Advance Timing
6. Acceleration
7. Start Power
8. Start Current Limit Function
9. Current Limit Function
10. Reverse Function
11. Reverse Delay
12. Max Reverse Amount
13. Neutral Width
14. Speed Mixing Brake
15. ABS Brake Function
16. Auto Brake Amount
17. Minimum Brake Amount
18. Maximum Brake Amount
19. Factory Setting
Every time the throttle stick is moved from the closed position to the full power position and again to the
closed position (closed > full power > closed is one cycle ) the program will change. The Red LED will
flash in accordance with the features as follows
