GLP
German Light Products GmbH
(instruction version 1.33 / from software version 1.53)
33
4) Pull the Gobo holder back into the central spring-holder jig in the middle
of the Gobo wheel and snap it in. You can open the central spring-
holder with a bent screwdriver through a hole from the opposite side of
the wheel.
5) Push the Gobo holder in the dedicated hub.
Attention:
There must be no gap between the Gobo holder and the
wheel afterwards. Check for a tight fit.
6.3.3 Changing Color filters
1) The fixture is open as described above. The optical plug-in module
is taken out and opened as well.
2) Pull the Color filter holder carefully out of
the central spring-holder jig. Use for
example a small flat-noses pliers or do it
by hand.
Note:
This will work best if the two "open"
positions are overlapping.
3) Exchange the complete Color filter holder and
pull it back into the central spring-holder jig. You can
also use a small screwdriver to lift the spring carefully.
Attention:
Please make sure that the Color filter holder is snapped in
and fits tight.
